Digisol DG-GS4826S Management Manual page 848

C 32 | Interface Commands
HAPTER
description
The 1000BASE-T and 10GBASE-T standard does not support forced
u
mode. Auto-negotiation should always be used to establish a
connection over any 1000BASE-T and 10GBASE-T port or trunk.
When auto-negotiation is enabled with the
u
switch will negotiate the best settings for a link based on the
capabilities command. When auto-negotiation is disabled, you must
manually specify the link attributes with the
flowcontrol commands.
E
XAMPLE
The following example configures Ethernet port 5 capabilities to include
100half and 100full.
Console(config)#interface ethernet 1/5
Console(config-if)#capabilities 100half
Console(config-if)#capabilities 100full
Console(config-if)#capabilities flowcontrol
Console(config-if)#
R C
ELATED OMMANDS
negotiation (850)
speed-duplex (852)
flowcontrol (849)
This command adds a description to an interface. Use the no form to
remove the description.
S
YNTAX
description string
no description
string - Comment or a description to help you remember what is
attached to this interface. (Range: 1-64 characters)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
The description is displayed by the
the running-configuration file. An example of the value which a network
manager might store in this object is the name of the manufacturer, and
the product name.
– 848 –
negotiation
speed-duplex
show interfaces status command and in
command, the
and