Digisol DG-GS4826S Management Manual page 141

100f - Supports 100 Mbps full-duplex operation
n
1000f (Gigabit ports only) - Supports 1000 Mbps full-duplex
n
operation
10Gf (10 Gigabit ports only) - Supports 10 Gbps full-duplex
n
operation
Sym - Check this item to transmit and receive pause frames.
n
FC - Flow control can eliminate frame loss by "blocking" traffic from
n
end stations or segments connected directly to the switch when its
buffers fill. When enabled, back pressure is used for half-duplex
operation and IEEE 802.3-2005 (formally IEEE 802.3x) for full-
duplex operation.
Avoid using flow control on a port connected to a hub unless it is
actually required to solve a problem. Otherwise back pressure
jamming signals may degrade overall performance for the segment
attached to the hub.
(Default: Autonegotiation enabled on Gigabit and 10 Gigabit ports;
Advertised capabilities for
1000BASE-T – 10half, 10full, 100half, 100full, 1000full;
1000Base-SX/LX/LH – 1000full
10GBASE-SR/LR/ER - 10Gfull
10GBASE-T - 10Gfull)
Speed/Duplex – Allows you to manually set the port speed and
u
duplex mode. (i.e., with auto-negotiation disabled)
Flow Control – Allows automatic or manual selection of flow control.
u
W I
EB NTERFACE
To configure port connection parameters:
1. Click Interface, Port, General.
2. Select Configure by Port List from the Action List.
3.
Modify the required interface settings.
4.
Click Apply.
– 141 –
C 5 | Interface Configuration
HAPTER
Port Configuration