Digisol DG-GS4826S Management Manual page 157

By default, the Actor Admin Key is determined by port's link speed, and
copied to Oper Key. The Partner Admin Key is assigned to zero, and the
Oper Key is set based upon LACP PDUs received from the Partner.
System Priority – LACP system priority is used to determine link
u
aggregation group (LAG) membership, and to identify this device to
other switches during LAG negotiations. (Range: 0-65535;
Default: 32768)
System priority is combined with the switch's MAC address to form the
LAG identifier. This identifier is used to indicate a specific LAG during
LACP negotiations with other systems.
Port Priority – If a link goes down, LACP port priority is used to select
u
a backup link. (Range: 0-65535; Default: 32768)
Configuring LACP settings for a port only applies to its administrative
N :
OTE
state, not its operational state, and will only take effect the next time an
aggregate link is established with that port.
Configuring the port partner sets the remote side of an aggregate
N :
OTE
link; i.e., the ports on the attached device. The command attributes have
the same meaning as those used for the port actor.
W I
EB NTERFACE
To configure the admin key for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregator from the Step list.
3. Set the Admin Key for the required LACP group.
4.
Click Apply.
Figure 39: Configuring the LACP Aggregator Admin Key
– 157 –
C 5 | Interface Configuration
HAPTER
Trunk Configuration