Digisol DG-GS4826S Management Manual page 1037

C
OMMAND
Interface Configuration (VLAN)
C
OMMAND
IGMP (including query functions) can be enabled for specific VLAN
u
interfaces at Layer 3 through the ip igmp command.
When a multicast routing protocol, such as PIM - Dense Mode, is
u
enabled, IGMP is also enabled.
E
XAMPLE
Console(config)#interface vlan 1
Console(config-if)#ip igmp
Console(config-if)#end
Console#show ip igmp interface
IGMP
IGMP Version
IGMP Proxy
IGMP Unsolicited-report-interval : 400 sec
Robustness variable
Query Interval
Query Max Response Time
Last Member Query Interval
Querier
Joined Groups :
Static Groups :
Console#
R
ELATED
ip igmp snooping (1001)
show ip igmp snooping (1015)
ip igmp last-
This command configures the frequency at which to send IGMP group-
specific or IGMPv3 group-source-specific query messages in response to
member-query-
receiving a group-specific or group-source-specific leave message. Use the
interval
no form to restore the default setting.
S
YNTAX
ip igmp last-member-query-interval seconds
no ip igmp last-member-query-interval
D
EFAULT
10 (1 second)
C
OMMAND
Interface Configuration (VLAN)
M
ODE
U
SAGE
C
OMMANDS
seconds - The frequency at which the switch sends group-specific or
group-source-specific queries upon receipt of a leave message.
(Range: 1-255 tenths of a second)
S
ETTING
M
ODE
– 1037 –
C 42 | Multicast Filtering Commands
HAPTER
: Enabled
: 2
: Disabled
: 2
: 125 sec
: 100 (resolution in 0.1 sec)
: 10 (resolution in 0.1 sec)
: 0.0.0.0
IGMP (Layer 3)