Digisol DG-GS4826S Management Manual page 151

Not Supported: This message is displayed for any Gigabit Ethernet
n
ports linked up at a speed lower than 1000 Mbps, or for any 10G
Ethernet ports.
Impedance mismatch: Terminating impedance is not in the
n
reference range.
Ports are linked down while running cable diagnostics.
u
P
ARAMETERS
These parameters are displayed in the web interface:
Port – Switch port identifier. (Range: 1-26/50)
u
Test Result – The results include common cable failures, as well as the
u
status and approximate distance to a fault, or the approximate cable
length if no fault is found.
Accuracy – The accuracy of the reported length to a fault.
u
(The accuracy displays "0" when no problem is found.)
Last Updated – Shows the last time this port was tested.
u
W I
EB NTERFACE
To test the cable attached to a port:
1. Click Interface, Port, Cable Test.
2. Click Test for any port to start the cable test.
Figure 32: Performing Cable Tests
– 151 –
C 5 | Interface Configuration
HAPTER
Port Configuration