Digisol DG-GS4826S Management Manual page 750

C 29 | Authentication Commands
HAPTER
Web Server
ip http secure-port
To specify a secure-site certificate, see "Replacing the Default Secure-
u
site Certificate" on page 306. Also refer to the
command.
E
XAMPLE
Console(config)#ip http secure-server
Console(config)#
R C
ELATED OMMANDS
ip http secure-port (750)
copy tftp https-certificate
show system (653)
This command specifies the UDP port number used for HTTPS connection to
the switch's web interface. Use the no form to restore the default port.
S
YNTAX
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
D S
EFAULT ETTING
443
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
You cannot configure the HTTP and HTTPS servers to use the same
u
port.
If you change the HTTPS port number, clients attempting to connect to
u
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
E
XAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
R C
ELATED OMMANDS
ip http secure-server (749)
show system (653)
– 750 –
(659)
copy tftp https-certificate