You can also set the switch to use new firmware or configuration settings
without overwriting the current version. Just download the file using a
different name from the current version, and then set the new file as the
startup file.
CLI R
EFERENCES
"copy" on page 659
u
P
ARAMETERS
The following parameters are displayed in the web interface:
Copy Type – The firmware copy operation includes these options:
u
FTP Upgrade – Copies a file from an FTP server to the switch.
n
FTP Download – Copies a file from the switch to an FTP server.
n
HTTP Upgrade – Copies a file from a management station to the
n
switch.
HTTP Download – Copies a file from the switch to a management
n
station
TFTP Upgrade – Copies a file from a TFTP server to the switch.
n
TFTP Download – Copies a file from the switch to a TFTP server.
n
FTP/TFTP Server IP Address – IP address of an FTP or TFTP server.
u
User Name – The user name for FTP server access.
u
Password – The password for FTP server access.
u
File Type – Specify Operation Code to copy firmware.
u
File Name – The file name should not contain slashes (\ or /), the
u
leading letter of the file name should not be a period (.), and the
maximum length for file names is 31 characters for files on the switch.
(Valid characters: A-Z, a-z, 0-9, ".", "-", "_")
Up to two copies of the system software (i.e., the runtime firmware)
N
:
OTE
can be stored in the file directory on the switch.
The maximum number of user-defined configuration files is limited
N
:
OTE
only by available flash memory space.
The file
N
:
"Factory_Default_Config.cfg"
OTE
or management station, but cannot be used as the destination file name on
the switch.
– 119 –
C
4
| Basic Management Tasks
HAPTER
Managing System Files
can be copied to a file server