Digisol DG-GS4826S Management Manual page 83

bits (from the left) of the prefix that form the network address, and is
expressed as a decimal number. For example, all IPv6 addresses that start
with the first byte of 73 (hexadecimal) could be expressed as
73:0:0:0:0:0:0:0/8 or 73::/8.
To generate an IPv6 global unicast address for the switch, complete the
following steps:
1. From the global configuration mode prompt, type "interface vlan 1" to
access the interface-configuration mode. Press <Enter>.
2.
From the interface prompt, type "ipv6 address ipv6-address" or
"ipv6 address ipv6-address/prefix-length," where "prefix-length"
indicates the address bits used to form the network portion of the
address. (The network address starts from the left of the prefix and
should encompass some of the ipv6-address bits.) The remaining bits
are assigned to the host interface. Press <Enter>.
3. Type "exit" to return to the global configuration mode prompt. Press
<Enter>.
4. To set the IP address of the IPv6 default gateway for the network to
which the switch belongs, type "ipv6 default-gateway gateway," where
"gateway" is the IPv6 address of the default gateway. Press <Enter>.
Console(config)#interface vlan 1
Console(config-if)#ipv6 address 2001:DB8:2222:7272::/64
Console(config-if)#exit
Console(config)#ipv6 default-gateway 2001:DB8:2222:7272::254
Console(config)end
Console#show ipv6 interface
Vlan 1 is up
IPv6 is enable.
Link-local address:
FE80::200:E8FF:FE93:82A0/64
Global unicast address(es):
2001:DB8:2222:7272::/64, subnet is 2001:DB8:2222:7272::/64
2005::212:CFFF:FE0B:4600, subnet is ::
Joined group address(es):
FF02::1:2
FF02::1:FF00:0
FF02::1:FF93:82A0
FF02::1
IPv6 link MTU is 1280 bytes
ND DAD is enabled, number of DAD attempts: 2.
ND retransmit interval is 1000 milliseconds
Console#
D C
YNAMIC ONFIGURATION
Obtaining an IPv4 Address
If you select the "bootp" or "dhcp" option, the system will immediately
start broadcasting service requests. IP will be enabled but will not function
until a BOOTP or DHCP reply has been received. Requests are broadcast
every few minutes using exponential backoff until IP configuration
information is obtained from a BOOTP or DHCP server. BOOTP and DHCP
– 83 –
C 2 | Initial Switch Configuration
HAPTER
Basic Configuration