Digisol DG-GS4826S Management Manual page 262

Layer 3 gigabit ethernet managed switch
Table of Contents

Advertisement

C
12
| Quality of Service
HAPTER
Creating QoS Policies
Violate – Specifies whether the traffic that exceeds the
n
maximum rate (CIR) will be dropped or the DSCP service level
will be reduced.
Set IP DSCP – Decreases DSCP priority for out of
n
conformance traffic. (Range: 0-63)
Drop – Drops out of conformance traffic.
n
srTCM (Police Meter) – Defines the committed information rate
n
(CIR, or maximum throughput), committed burst size (BC, or burst
rate) and excess burst size (BE), and the action to take for traffic
conforming to the maximum throughput, exceeding the maximum
throughput but within the excess burst size, or exceeding the
excess burst size. In addition to the actions defined by this
command to transmit, remark the DSCP service value, or drop a
packet, the switch will also mark the two color bits used to prioritize
service to packets of different colors.
The color modes include "Color-Blind" which assumes that the
packet stream is uncolored, and "Color-Aware" which assumes that
the incoming packets are pre-colored. The functional differences
between these modes is described at the beginning of this section
under "srTCM Police Meter."
Committed Information Rate (CIR) – Rate in kilobits per
n
second. (Range: 1-1000000 kbps or maximum port speed,
whichever is lower)
The rate cannot exceed the configured interface speed.
Committed Burst Size (BC) – Burst in bytes.
n
(Range: 64-524288 bytes)
The burst size cannot exceed 16 Mbytes.
Exceeded Burst Size (BE) – Burst in excess of committed
n
burst size. (Range: 64-524288 bytes)
The burst size cannot exceed 16 Mbytes.
Conform – Specifies whether that traffic conforming to the
n
maximum rate (CIR) will be transmitted without any change to
the DSCP service level, or if the DSCP service level will be
modified.
Transmit – Transmits in-conformance traffic without any
n
change to the DSCP service level.
Exceed – Specifies whether traffic that exceeds the maximum
n
rate (CIR) but is within the excess burst size (BE) will be
dropped or the DSCP service level will be reduced.
– 262 –

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dg-gs4850s

Table of Contents