Digisol DG-GS4826S Management Manual page 463

designated multicast services supported by the MVR VLAN. Just
remember that only IGMP version 2 or 3 hosts can issue multicast
join or leave messages. If MVR must be configured for an IGMP
version 1 host, the multicast groups must be statically assigned
(see "Assigning Static Multicast Groups to Interfaces" on page
Non-MVR – An interface that does not participate in the MVR VLAN.
n
(This is the default type.)
Oper. Status – Shows the link status.
u
MVR Status – Shows the MVR status. MVR status for source ports is
u
"Active" if MVR is globally enabled on the switch. MVR status for
receiver ports is "Active" only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.
Immediate Leave – Configures the switch to immediately remove an
u
interface from a multicast stream as soon as it receives a leave
message for that group. (This option only applies to an interface
configured as an MVR receiver.)
W I
EB NTERFACE
To configure interface settings for MVR:
1. Click Multicast, MVR.
2. Select Configure Interface from the Action list.
3. Set each port that will participate in the MVR protocol as a source port
or receiver port, and optionally enable Immediate Leave on any
receiver port to which only one subscriber is attached.
4. Click Apply.
Figure 270: Configuring Interface Settings for MVR
– 463 –
C 16 | Multicast Filtering
HAPTER
Multicast VLAN Registration
464).