Digisol DG-GS4826S Management Manual page 264

C 12 | Quality of Service
HAPTER
Creating QoS Policies
Conform – Specifies whether that traffic conforming to the
n
maximum rate (CIR) will be transmitted without any change to
the DSCP service level, or if the DSCP service level will be
modified.
Transmit – Transmits in-conformance traffic without any
n
change to the DSCP service level.
Exceed – Specifies whether traffic that exceeds the maximum
n
rate (CIR) but is within the peak information rate (PIR) will be
dropped or the DSCP service level will be reduced.
Set IP DSCP – Decreases DSCP priority for out of
n
conformance traffic. (Range: 0-63).
Drop – Drops out of conformance traffic.
n
Violate – Specifies whether the traffic that exceeds the peak
n
information rate (PIR) will be dropped or the DSCP service level
will be reduced.
Set IP DSCP – Decreases DSCP priority for out of
n
conformance traffic. (Range: 0-63).
Drop – Drops out of conformance traffic.
n
W I
EB NTERFACE
To configure a policy map:
1.
Click Traffic, DiffServ.
2. Select Configure Policy from the Step list.
3. Select Add from the Action list.
4. Enter a policy name.
5. Enter a description.
6.
Click Add.
Figure 121: Configuring a Policy Map
– 264 –