Digisol DG-GS4826S Management Manual page 426

C 16 | Multicast Filtering
HAPTER
Layer 2 IGMP (Snooping and Query)
When the switch is configured to use IGMPv3 snooping, the
N :
OTE
snooping version may be downgraded to version 2 or version 1, depending
on the version of the IGMP query packets detected on each VLAN.
IGMP snooping will not function unless a multicast router port is
N :
OTE
enabled on the switch. This can accomplished in one of two ways. A static
router port can be manually configured (see
for a Multicast Router" on page
never timed out, and will continue to function until explicitly removed. The
other method relies on the switch to dynamically create multicast routing
ports whenever multicast routing protocol packets or IGMP query packets
are detected on a port.
: A maximum of up to 1024 multicast entries can be maintained for
N
OTE
IGMP snooping and Multicast Routing when both of these features are
enabled. Once the table is full, no new entries are learned. Any subsequent
multicast traffic not found in the table is dropped if unregistered-flooding is
disabled (default behavior) and no router port is configured in the attached
VLAN, or flooded throughout the VLAN if unregistered-flooding is enabled
(see "Configuring IGMP Snooping and Query Parameters" on page
Static IGMP Router Interface – If IGMP snooping cannot locate the IGMP
querier, you can manually designate a known IGMP querier (i.e., a
multicast router/switch) connected over the network to an interface on
your switch (page 431). This interface will then join all the current
multicast groups supported by the attached router/switch to ensure that
multicast traffic is passed to all appropriate interfaces within the switch.
Static IGMP Host Interface – For multicast applications that you need to
control more carefully, you can manually assign a multicast service to
specific interfaces on the switch
IGMP Snooping with Proxy Reporting – The switch supports last leave, and
query suppression (as defined in DSL Forum TR-101, April 2006):
Last Leave: Intercepts, absorbs and summarizes IGMP leaves coming
u
from IGMP hosts. IGMP leaves are relayed upstream only when
necessary, that is, when the last user leaves a multicast group.
Query Suppression: Intercepts and processes IGMP queries in such a
u
way that IGMP specific queries are never sent to client ports.
The only deviation from TR-101 is that report suppression, and the
marking of IGMP traffic initiated by the switch with priority bits as defined
in R-250 is not supported.
– 426 –
"Specifying Static Interfaces
431). Using this method, the router port is
(page 433).
427).