Digisol DG-GS4826S Management Manual page 378

C 15 | Basic Administration Protocols
HAPTER
Link Layer Discovery Protocol
should be accompanied by a port and protocol VLAN TLV that
indicates the VLAN identifier (VID) associated with the management
address reported by this TLV.
Port Description – The port description is taken from the ifDescr
n
object in RFC 2863, which includes information about the
manufacturer, the product name, and the version of the interface
hardware/software.
System Capabilities – The system capabilities identifies the
n
primary function(s) of the system and whether or not these primary
functions are enabled. The information advertised by this TLV is
described in IEEE 802.1AB.
System Description – The system description is taken from the
n
sysDescr object in RFC 3418, which includes the full name and
version identification of the system's hardware type, software
operating system, and networking software.
System Name – The system name is taken from the sysName
n
object in RFC 3418, which contains the system's administratively
assigned name. To configure the system name, see
System Information" on page
802.1 Organizationally Specific TLVs – Configures IEEE 802.1
u
information included in the TLV field of advertised messages.
Protocol Identity – The protocols that are accessible through this
n
interface (see "Protocol VLANs" on page
VLAN ID – The port's default VLAN identifier (PVID) indicates the
n
VLAN with which untagged or priority-tagged frames are associated
(see "IEEE 802.1Q VLANs" on page
VLAN Name – The name of all VLANs to which this interface has
n
been assigned (see
"Protocol VLANs" on page
Port And Protocol VLAN ID – The port-based and protocol-based
n
VLANs configured on this interface (the port-based and protocol-
based VLANs configured on this interface (see
on page 171 and
802.3 Organizationally Specific TLVs – Configures IEEE 802.3
u
information included in the TLV field of advertised messages.
Link Aggregation – The link aggregation capabilities, aggregation
n
status of the link, and the IEEE 802.3 aggregated port identifier if
this interface is currently a link aggregation member.
Max Frame Size – The maximum frame size. (See
n
Support for Jumbo Frames" on page 116
configuring the maximum frame size for this switch
– 378 –
113.
171).
"IEEE 802.1Q VLANs" on page 171
195).
"Protocol VLANs" on page
"Displaying
195).
and
"IEEE 802.1Q VLANs"
195).
"Configuring
for information on