Configuring The Gateway Address Field When Nat Is Enabled; Displaying Dhcp Configuration - Avaya 1000 Series Configuration Manual
Secure router
Hide thumbs
Also See for 1000 Series:
- Reference (700 pages) ,
- Manual (570 pages) ,
- Hardware installation and maintenance (262 pages)
Table of Contents
Advertisement
DHCP Relay
Configuring the Gateway Address field when NAT is enabled
The following example shows configuring 4 DHCP server addresses with NAT enabled.
Router/configure/interface/ethernet 0> dhcp-relay 20.1.1.1 192.168.20.1
Router/configure/interface/ethernet 0> dhcp-relay 20.1.1.2 192.168.20.1
Router/configure/interface/ethernet 0> dhcp-relay 20.1.1.3 192.168.20.1
Router/configure/interface/ethernet 0> dhcp-relay 20.1.1.4 192.168.20.1
Displaying DHCP Configuration
The following screen captures show the displayed results of issuing show commands relevant
to DHCP relay, with and without gateway addresses configured.
Figure 6: show dhcp_relay Command
Figure 7: show dhcp_relay Command
44
Avaya Secure Router 1000 Series Configuration Guide
December 2010
Advertisement
Table of Contents
Troubleshooting
