13.1.1.2 Removing the front panel module
Figure 205: Disconnecting the front panel cable
Ê Disconnect the front panel cable from the system board (1).
Ê If applicable, disconnect the front VGA cable from the system board see
section
"Removing the front VGA cable" on page
Ê Push the locking latches upward (2) to disengage the locking mechanism.
Ê Carefully pull the front panel module out of its bay (3).
V
CAUTION!
Ensure that none of the cables are strained or damaged!
Ê If the front VGA connector has been installed in the defective front panel
module, remove the cable as described in section
connector" on page
13.1.1.3 Installing the front panel module
Ê If the front VGA connection is to be installed in the new front panel module,
install the front VGA cable as described in section
connector" on page
RX2520 M1
321.
316.
Upgrade and Maintenance Manual
Front panel and external connectors
320.
"Removing the front VGA
"Installing the front VGA
313