Removing The Accessible Drive Dummy Module - Fujitsu PRIMERGY TX140 S1 Upgrade And Maintenance Manual

Ê Open the side / top cover as described in section
on page 67 (rack server) or
server).
Ê Pull out the ID card and open the front cover as described in section
"Removing the rack front cover" on page 69
front cover" on page 74

12.2.3 Removing the accessible drive dummy module

Figure 184: Removing the dummy module
Ê Press in on the locking latches on both EasyClick rails (1) to disengage the
locking mechanism.
Ê Pull the dummy module out of its bay (2).
V
CAUTION!
Save the dummy module for future use.
Always replace dummy modules into unused drive bays to comply with
applicable EMC regulations and satisfy cooling requirements.
TX140 S1
"Removing the side cover" on page 71
(tower server).
Upgrade and Maintenance Manual
Accessible drives
"Removing the top cover"
(rack server) or "Removing the
(tower
331