Cf Memory Card - Studer OnAir 3000 Operating Instructions Manual

2.2.3

CF Memory Card

Important
2.2.4 USB Memory Device
Important
2.2.5 adjustments, repair, Cleaning
Danger
Replacing the Supply Unit
Cleaning
Document generated: 10.10.14
The OnAir 3000's main screen module is equipped with a CompactFlash (CF)
memory card slot. This allows to save console snapshots to the CF card or
load them from the CF card to the console memory, which offers a convenient
possibility for backup purposes or for copying parameter settings from one
console to one or several others. Supported/recommended/usable CF card
sizes are 256 and 512 MB.
Recommended CF card types are SanDisk_Ultra_II or Swissbit C-300.
The CF card device MUST NOT BE REMOVED from the slot DURING
DATA ACCESS – only remove it after its LED has stopped flashing!
SW V3.0 and up also support external memory devices connected to the main
screen's USB slot for the same purposes as mentioned above.
The USB memory device MUST NOT BE REMOVED from the socket
DURING DATA ACCESS – only remove it after its LED has stopped flash-
ing!
All internal adjustments as well as repair work on this product must be per-
formed by expert technicians!
The primary fuse is located within the power supply module and cannot be
changed. In case of failure, the complete power supply unit must be replaced.
Please contact your nearest Studer representative.
Do not use any liquids to clean the exterior of the unit. A soft, dry cloth or
brush will usually do.
For cleaning the display windows, most of the commercially available
window or computer/TV screen cleaners are suited. Use only a slightly damp
(never wet) cloth. Never use any solvent!
SW V6.0
OnAir 3000 Digital Mixing Console
General 2-5