Studer OnAir 3000 Operating Instructions Manual page 14

Appendix
Appendix 2: Mains Connector Strain Relief
XII
For anchoring connectors without a mechanical lock (e.g. IEC mains connec-
tors), we recommend the following arrangement:
Procedure: The cable clamp shipped with your unit is auto-adhesive. For mounting please
follow the rules below:
• The surface to be adhered to must be clean, dry, and free from grease, oil,
or other contaminants. Recommended application temperature range is
+20 °C to +40 °C
• Remove the plastic protective backing from the rear side of the clamp and
apply it firmly to the surface at the desired position. Allow as much time as
possible for curing. The bond continues to develop for as long as 24 hours
• For improved stability, the clamp should be fixed with a screw. For this
purpose, a self-tapping screw and an M4 bolt and nut are included
• Place the cable into the clamp as shown in the illustration above and firmly
press down the internal top cover until the cable is fixed