Studer OnAir 3000 Operating Instructions Manual page 257

OnAir Digital Mixing Consoles
(cont.)
further Note :
6-16 Configuration
Since Livewire Listeners are logical sources of format stereo, the OnAir
application software (especially the Configuration Tool) handles consecutive
sources (Source Right, etc.) as known from other logical sources - they are
ignored and grayed out.
LVDS inputs associated to Livewire I/O cards can also be mapped to Logi-
calInputs, but without a Listener mapped to the first source of a Logical
Input, neither stream selection/patching nor label transfer is provided for that
LogicalInput.
Line / Mic Changes the view of the channel page in such a way that only the parameters
corresponding to the input type are displayed. Selections: Line or Mic. If Mic
is selected, remote control of the mic preamplifier is automatically enabled.
Note : If the LogicalInput is a Relink NetConsumer, Line/Mic cannot be changed.
The type is always inherited from the NetSource. In this case Line from
NetSource or Mic from NetSource is indicated. (See screenshot above).
If Line is selected, the mic preamplifier settings are not accesible at all.
In case where the LogicalInput is mapped to a physical Mic/Line input card,
the mic preamplifier settings are automatically set as follows :
• Gain according to Maximum Level and Analog Trim Level
• +48V = Off
SW V6.0 Document generated: 10.10.14