Studer OnAir 3000 Operating Instructions Manual page 178

Codec Status
Busy Return Lines
Document generated: 10.10.14
Locked – codec #1 is in use and locked to facility #1304; gray text on red
button. Cannot be selected. Listen mode is disabled, too.
Busy – codec #12 is in use, including the return line, by facility #3303; In
this example the LineTakeOver setting is off and therefore it's only possible
to select this line in listen mode. gray text on light gray button.
Reserved – codec #4 is reserved for facility #3301; gray text on light gray
button. May be selected only by facility #3301, including the return line. All
others may select it in listen mode (external input 1 to 8).
Active – codec #6 is ready and connected to a codec in Brøndby; black text
on light gray button. It is possible to select this line, including the return line
(external line 1 to 16).
Unused – all codecs without a specific name are not connected; black text
on light gray button.
If an external line is connected to a four-wire input of one facility, the line
is busy. The name of this facility is distributed by the RCS to other facilities
and it is only possible to connect a return line from another facility, if this
other facility has it's LineTakeOver settings = ON.
A line is busy as long as:
• the four-wire input to which the external line is connected is assigned to a
desk fader; de-assigning the input from the desk automatically disconnects
the line
• the external line is connected to the four-wire input of a facility. It can be
disconnected with the NONE button in the CHAN - Input page.
• no disconnect tag is specified or disconnect is specified as „Yes" in the file
probel_contr_ext.ini. For details please refer to
SW V6.0
OnAir 3000 Digital Mixing Console
chapter 5.8.8.3.
Operation 5-115