Logical Outputs; Selections; Meter Sources; Input Groups - Studer OnAir 3000 Operating Instructions Manual

7.4.5

Logical outputs

7.4.6

selections

7.4.6.1

Meter sources

7.4.6.2

input groups

Document generated: 10.10.14
Configuration Tool: Config → LogicalOutputs
The following parameters have to be configured according to AB DESK
Mode IO Config.xls:
• Label
• Left/Right CoreOut
Configuration Tool: Config → Selections → ...
A Selection is the means to specify the desired list of items that should be
accessible either from within the User GUI or on the desk surface, e.g. the
LogicalInputs in an Input Group, or the meter sources that can be selected
for the main meter.
All these Selections must be configured considering the information provided
by
• AB DESK Mode IO Config.xls
• AB DESK Mode Desk Resources.xls
Configuration Tool: Config → Selections → MeterSrc
The internal signals selectable as Main Meter Source can be configured for
each level meter.
Note:
Only signals related to the corresponding desk should be defined; e.g. PGMA
must not be added to the Meter 3 Src list if it will not be used on the second-
ary desk.
Configuration Tool: Config → Selections → Inp Grps
Both primary and secondary desk need their own input groups; e.g. Input
Groups 1...4 for the primary desk, 5...8 for the secondary desk.
Note: Only LogicalInputs of the primary desk should be added to the Inp Grps
Selection of the primary desk; the same applies to the secondary desk.
SW V6.0
OnAir 3000 Digital Mixing Console
A/B Desk Configuration 7-11