System Time - Studer OnAir 3000 Operating Instructions Manual

6.5.15

System Time

Time / Date
Time Sync Ref
OnAir 1500/2500:
NTP Time Server
Time Zone
Automatic Daylight Saving
Document generated: 10.10.14
On this page, all settings for operation with the internal real-time clock or an
external time reference signal are made.
The system time and date may be set either on this page or on the Admin
- Date Time page. When touching one of these fields, a keyboard pops up;
enter the desired time or date as described in
Time field can be entered by using the decimal point button.
The type of external time reference signal can be selected here from: None,
MONITORA (time information according to the Monitora protocol, e.g. from
a Studer DigiMedia CAB system), Ext.Time Sync*, or NTP (if the console
has access to an internet time server over a network). If None is selected, the
console operates on its own, internal real-time clock.
Ext.Time Sync is not supported by the OnAir 1500/2500 console.
* The Ext. Time Sync button is displayed only if an optional Time Sync card
is installed and connected to a time receiver; selection of the input signal
format is performed with DIP switches on the card (refer to OnAir 3000
service instructions, chapter 3). The optional Time Sync card can be used
with Compact SCore systems and, since SW V3.1, with SCore Live systems
as well. In the latter case, it must be installed in a custom 19"/1U frame and
linked to the COM2 serial port of the SCore Live frame.
If NTP has been selected above, the NTP time server's web address is set
here. When touching this button, a keyboard appears for entering the address.
Proceed according to the corresponding paragraph in
For SW V3.0 and up, IP addresses are supported for defining the NTP time
server as well.
Enter your local time zone here. In the example above, the (GMT +01:00)
Amsterdam/Berlin/Bern/Rome/Stockholm/Vienna time zone is selected.
Automatic daylight saving time for the internal watch can be activated here,
according to the selected time zone; this is independent from the current
external time sync reference.
SW V6.0
OnAir Digital Mixing Consoles
chapter 6.5.1. The colons in the
chapter 6.5.1.
Configuration 6-33