Studer OnAir 3000 Operating Instructions Manual page 312

Outgoing TB:
Advanced Mode
Document generated: 10.10.14
• Config – LogicalInputs – LogicalInputX – Source(Left):
Select a used LogicalInput for the TB mic. It should not be in any of the
InputSelections as we do not want to assign it to a StripChannel (shall not
be assigned to a channel strip).
Configure the Source(Left) to be the TB Mic signal.
• Config – LogicalInputs – LogicalInputX – Input Format:
Set the input to mono.
• Config – LogicalInputs – LogicalInputX – Line/Mic:
Set the input to mic.
• In order to setup the analog mic gain of the TB mic (must be connected
to a mic input card), assign it temporarily to a strip channel and tweak the
gain from within the Channel – Input page of the user GUI.
• TalkBack – TalkBack – Source:
Set the source of a TB input from the desired monitoring location, where
you want to talk from, to the appropriate LogicalInput.
• Desk Common – XLSection – TB Source:
Specify the TB source for the XL box to be the TB input where the Logi-
calInput is connected to.
• Config – FixedOutputs – Left Core Out:
Configure the physical output mapping of each TB destination to the des-
dired output signal.
(V3.2 or higher) – Listening to External Lines not assigned to a Fader:
In contrast to the 'legacy mode' where the XL box usea a PFL, AUX or N–X
bus for listening, the 'advanced mode' provides:
• Listening to external lines that are currently not on a fader
• Automatic listening on HP, TB Speaker or monitor LSP without selecting
the XL box listening bus as monitor source
SW V6.0
OnAir Digital Mixing Consoles
Configuration 6-71