Relink; Aoip; Consuming Livewire Streams - Studer OnAir 3000 Operating Instructions Manual

OnAir 3000 Digital Mixing Console
5.8.6

RELinK

5.8.7

AoiP

5.8.7.1

Consuming Livewire Streams

5-110 Operation
('Resource Linking', the feature formerly called 'I/O Sharing')
The OnAir 3000's I/O sharing allows routing a physical audio input to more
than one logical audio input.
If a physical audio input has unique control parameters (such as the micro-
phone gain in a microphone input) and if this physical audio input is routed
to more than one logical audio input, controlling these resources is working
in parallel on all the corresponding channel strips.
For I/O sharing details and configuration, refer to
The OnAir AoIP feature provides handling of AoIP streams in the D21m I/O
system.
The first AoIP I/O card available is the D21m Livewire
On one side, AoIP streams within the network can be selected and dynami-
cally assigned to Logical Inputs and on the other side all console outputs may
provide AoIP streams to the network to be consumed by other OnAir consoles,
third party AoIP network devices or a computers using AoIP virtual sound
card drivers.
Livewire is a registered trademark of Axiaaudio
TM
The OnAir AoIP feature allows the selection of any Livewire stream within
the network as source of a Logical Input.
The so called Stream Patching is seamless integrated into the existing input
selector of the MainScreen/Desk User Interface. See
Basically, streams are available for selection as long as they are advertised
within a network.
The corresponding Listener on the Livewire card consumes the selected
stream, even if the LogicalInput is not on a fader.
Under the following conditions OnAir application software provides Stream
Patching:
• Network- and Connector definition are properly configured as described
in chapter 6.6.
• The first source of the physical input mapping of the LogicalInput must
be mapped to a Listener of a Livewire card.
• Patch Control must not be disabled (Disable Patch Control) for the appro-
priate Listener
• The StripChannel to which the LogicalInput is currently assigned must not
be locked.
• The LogicalInput must not be on-air (on-air restriction).
• Any other console in a Relink network, consuming this LogicalInput must
not be on-air with this source.
Note: Livewire streams can only be patched to LogicalInputs. It is not possible
to patch Livewire streams to Patch Inputs* or other logical console inputs
(External Monitoring Sources, External PFL, etc).
*Patch Inputs only available on OnAir3000
SW V6.0
chapter 6.5.22.
card.
TM
chapter 5.3.2.1.
Document generated: 10.10.14