Custom Logics; Time Sync Card - Studer OnAir 3000 Operating Instructions Manual

OnAir 3000 Digital Mixing Console
5.12.4.16

Custom Logics

Error Code Error Type Error Text / Comment
Warning
8800
Warning
8805
Warning
8806
5.12.4.17

Time Sync Card

Error Code Error Type Error Text / Comment
Warning
9000
Warning
9001
5-156 Operation
CUSTOM LOGICS, Connection to CORE 'System71' lost. Remote GPIO and Custom Logics from that
CORE are not available.
Appears if the CORE looses the network connection to another CORE of a remote system, from which at
least one logical signal is consumed (Remote GPIO or Custom Logics).
CUSTOM LOGICS, More than 10 gates cascaded at Gate 'AND 21'! Source cleared.
Appears during configuration of a source of a Custom Logic, the limit of cascades is exceeded configuring
a new source.
The User Warning appears only on the Configuration Tool, where the source was configured.
CUSTOM LOGICS, Feedback detected at Gate 'AND 21'. Source cleared.
Appears during configuration of a source of a Custom Logic, if a feedback results.
The User Warning appears only on the Configuration Tool, where the source was configured.
TIME SYNC, No communication with Time Sync Card.
Appears during power-up or runtime if the TimeSyncRef is ExtTimeSync and the communication to the
Time Sync Card is lost.
TIME SYNC, Could not open port COMX.
Appears during init phase if the specified COM port cannot be opened.
SW V6.0 Document generated: 10.10.14