Signaling; Settings - Studer OnAir 3000 Operating Instructions Manual

S P SRC (Source) Selector CR / ST1
OnAir 1500/2500:
6.5.25

Signaling

6.5.25.1

Settings

OnAir Mode
Document generated: 10.10.14
The list of sources for the PFL/TB speaker (SP) that can be selected with the
SELECT rotary encoder on the CR (control room) and ST1 (studio 1) moni-
toring/talkback modules is defined here (for details see
5.3.2). Selection is done as described in
All router inputs and outputs may be selected here for monitoring purposes.
Studio 1 not supported.
Selects the condition for switching the ON AIR light on: Internal (i.e., when
at least one channel fader is open, this channel is ON, assigned to a master
output, this master is defined to be OnAir Relevant - see
the master fader is open), External (i.e., when an external on-air input on
the GPI interface is active), or Internal AND External (i.e., a logical AND
operation of both conditions).
SW V6.0
OnAir Digital Mixing Consoles
chapters 5.3.1
chapter 6.5.20.1.
chapter 6.5.11
Configuration 6-63
and
- and