Studer OnAir 3000 Operating Instructions Manual page 428

OnAir 3000 Digital Mixing Console
Management Console
Fix IP: 192.168.0.10
Subnet: 255.255.0.0
Gateway: 192.168.0.1
Netgear 16-Port
Switch FS516
Channel Screen
Desk
Fix IP: 192.168.90.110
Fix IP: 192.168.90.100
Subnet: 255.255.0.0
Subnet: 255.255.0.0
9.4.2.2 integrated Solution
9.4.2.3 Routed
9-18 Networking
Customer switch configurations for this type of network topology are avail-
able for
• Cisco 2960-8 (Master)
• Cisco 2960-8
Axia Livewire xNode
Fix IP: 10.0.0.10
Subnet: 255.255.255.0
Gateway: 10.0.0.1
Cisco C2960G-8 (Master/Gateway)
Switch IP VLan 1: 192.168.0.1 / 255.255.0.0
Switch IP VLan 2: 10.0.0.1 / 255.255.255.0
Core D21m Livewire card
Fix IP: 192.168.90.10 LW1 Fix IP: 10.0.0.11
Subnet: 255.255.0.0 LW2 Fix IP: 10.0.0.12
Gateway: 192.168.0.1
Subnet: 255.255.255.0
Gateway: 10.0.0.1
Not defined yet.
The Routed topology is to be preferred compared to the Integrated topology,
when integration with existing IT infrastructure is needed. The big advantage
is that data flow between the IT- and the OnAir Control network can be con-
trolled. In case of malfunction in the IT network, the OnAir Control network
will not be affected.
In the routed network solution one or more OnAir consoles are placed into
their own physical network (OnAir Control network). Using a router, the
OnAir Control network is connected to the IT network.
UDP multicast packets must be used by the OnAir consoles subsystems to
establish and maintain the DNet communication as they are routable in con-
trast to broadcast messages.
The switches and routers of the network must support IGMP V3.
The routed solution provides the same functionality as the integrated solution,
refer to chapter 9.4.1.2. The only difference is that the traffic between the
OnAir Control network and the IT network can be controlled by the router.
The picture on the next page shows an example of a routed network topology.
The Routed topology is used where different networks are brought together
by a router.
SW V6.0
Desk Core D21m Livewire card
Fix IP: 192.168.70.100 Fix IP: 192.168.70.10 LW1 Fix IP: 10.0.0.13
Subnet: 255.255.0.0 Subnet: 255.255.0.0 LW2 Fix IP: 10.0.0.14
Gateway: 192.168.0.1
Subnet: 255.255.255.0
Gateway: 10.0.0.1
Cisco C2960G-8
Switch IP VLan 1: 192.168.0.2 / 255.255.0.0
VLan 1/2 (Trunk)
VLan 1 (Control)
VLan 2 (Livewire)
Document generated: 10.10.14