Studer OnAir 3000 Operating Instructions Manual page 144

DJ Headphones
HP Split Mode
HP Split Balance
SP SRC Selection
Guest Headphones
PFL TO MON Function
Document generated: 10.10.14
If the monitoring source is 'Audition', the CR and Studio1 monitor speaker's
behavior is depending on the configuration: either muted (CUT), dimmed
(DIM), or unaffected (Nothing); in case of CUT or DIM, the corresponding
key is illuminated.
MONO
When selected, both left and right CR monitor speakers are fed with a mono
mix of the selected source.
CR
Output level setting of the CR monitor speakers. If talkback is active, the CR
monitor speaker level is dimmed and the DIM key is illuminated.
Note: For SW V3.0 and up, an automatic 'PFL to speaker' function has been intro-
duced. It switches from the selected speaker source over to PFL for as long
as PFL is active.
A DJ headphones connector (DJ
DJ
This control sets the level of the DJ headphones.
If the studio's talkback key is pressed, the headphones monitoring signal is
dimmed and the talkback signal is fed to the headphones. CUT and DIM have
no effect on the headphones signal, and the headphones output is not muted
if one of the control room microphones is on.
This mode is valid for the DJ headphones and has only effect on the CR
monitor speakers if LSP Split Mode is enabled. Split mode is controlled with
three keys of the MON/TB module :
MON
The DJ headphones signal is the same stereo signal as selected for the CR
monitor speakers by the CONTROL ROOM source selector. MON is lit if active.
PFL / MON
The left** DJ headphones signal is the mono SP SRC* signal, while the
right** one is a mono mix of the CR monitor signal as selected for the CR
monitor speakers by the source selector. If the SP SRC* signal is the same as
the CR monitor signal or no PFL is active, the headphones signal is the stereo
CR monitor signal as if MON were active
PFL / MON is illuminated if active.
PFL The stereo SP SRC* signal is fed to the DJ headphones. PFL is lit if active.
(these three keys are also available in the UserGUI, see
they are labeled MON, SP SRC/MON, SP SRC and have the same functionality)
The Balance can be controlled with the SP
is pressed. The current Balance setting is indicated by the associated LED
ring.
The HP BAL key is not available by default. It can be configured on the Desk
surface in the file Desk_KeyMapping.xml .
Please note that the Balance setting is only relevant as long as two signals
(SP SRC and MON) are provided to the DJ headphones.
The speaker source (SP SRC) can be selected with the Select rotary when the
SP SRC key is pressed.The currently selected speaker source is indicated by
the associated display. The SP SRC key is not available by default. It can be
configured on the Desk surface in the file Desk_KeyMapping.xml
The guest headphones are always fed with the same signal as the CR monitor
speakers, but without cut or dim functions. The guest headphones connector
is located in the SCore frame.
If PFL is active on any channel or if the external PFL input signal is selected,
PFL TO MON feeds the PFL signal not only to the DJ headphones but also to
the CR monitor speakers. If no signal is routed to the PFL bus, the signal for
the monitor loudspeakers is identical to the one selected by the CONTROL
SW V6.0
OnAir 3000 Digital Mixing Console
) is provided for monitoring purposes.
chapter
Rotary when the HP BAL key
5.3.4.3, there,
Operation 5-81