Routing Operation; Input Routing - Studer OnAir 3000 Operating Instructions Manual

OnAir 3000 Digital Mixing Console
5.8.4

Routing Operation

Input Routing

Output Routing
5-108 Operation
Input routing is either done with the channel's rotary encoder, or in the ROUT
- Input page on the main screen (see
Example: Routing a new source (MIC 2 to channel 7, instead of CD 1).
MIC 1
IN
DeEs
EQ
DYN
AUX
Unused Inputs
• Set the function of the rotary encoder of channel 7 to 'INP SEL'
• Turn the rotary encoder until the desired source is displayed in the channel
label display (MIC 2 in the example above)
• Press the 'OK' key next to the rotary encoder.
MIC 1
IN
DeEs
EQ
DYN
AUX
Unused Inputs
Now, the MIC 2 input is routed to channel 7, as shown above. All channel
settings are as they were set when this input was used the last time, except
for the fader value and the status of the ON and PFL keys; these are not
overwritten and remain in the current channel status before the re-routing
took place.
Output routing is done in the ROUT - Output page on the main screen (see
chapter 5.3.5.2).
SW V6.0
MIC 2
CD 1
IN IN
DeEs DeEs
EQ EQ
CD 1
DYN DYN
AUX AUX
7
MIC 2
CD 1
IN
IN
DeEs DeEs
EQ EQ
MIC 2
DYN DYN
AUX AUX
7
chapter 5.3.5.1).
Document generated: 10.10.14