Utilization For The Purpose Intended - Studer OnAir 3000 Operating Instructions Manual

2 General
2.1

Utilization for the purpose Intended

2.2 First Steps
2.2.1 Unpacking and Inspection
2.2.2 Installation
Primary Voltage
AC Supply Connection
Earthing
Temperature Regulations
D21m Frame
Document generated: 10.10.14
The OnAir 3000 mixing console is intended for professional use.
It is presumed that the unit is operated only by trained personnel. Servicing
is reserved to skilled technicians.
The electrical connections may be connected only to the voltages and signals
designated in this manual.
Your new unit is shipped in special packing which protects the units against
mechanical shock during transit. Care should be exercised when unpacking
so that the surfaces do not get damaged.
Verify that the content of the packing agrees with the items on the enclosed
shipping list.
Check the condition of the equipment for signs of shipping damage. If there
should be any complaints you should immediately notify the forwarding agent
and your nearest Studer distributor.
It is recommended to retain the original packing material because it offers
the best protection in case your equipment ever needs to be transported.
The power supply unit is auto-ranging; it can be used for voltages in a range
of 100 to 240 VAC, 50 to 60 Hz.
The attached female IEC 320/C13 cable socket has to be connected to an
appropriate cable by a trained technician, respecting your local regulations.
Refer to the 'Installation, Operation, and Waste Disposal' chapter at the begin-
ning of this manual.
This equipment must be earthed, due to the mains input filter network be ing
connected to the mains earth.
Some consideration must be given to the earthing arrangement of the sy stem,
at the center of which is the I/O frame. The frame is earthed to the mains
earth via the power supply. Ground loops may occur where signal processing
equip ment, patched to the frame, has its signal earth commoned to the equip-
ment chassis.
The unit must not be used in conditions of excessive heat or cold, near any
source of moisture, in excessively humid environments, or in positions where
it is likely to be subjected to vibration or dust. The ambient temperature range
for normal operation of the unit is +5...+40° C.
Under standard circumstances (open 19" frame) and an ambient temperature
between +5 and +40° C, the power dissipations listed below must not be
ex ceeded. Please note that these figures may change for special environments,
such as air-conditioned machine rooms, etc. For details refer to Appendix 1
at the beginning of this manual.
SW V6.0
OnAir 3000 Digital Mixing Console
General 2-3