Studer OnAir 3000 Operating Instructions Manual page 79

OnAir 3000 Digital Mixing Console
Input indicates the label of the
Logical Input currently assigned
to the selected Strip Channel.
Source Group indicates the
previously selected Stream
Group.
The None button allows
disconnecting the current
Stream.
The Back button closes the
Source Selector dialog and leads
back to the Input Selector dialog.
The Close button only closes
the Source Selector dialog.
Further functions common to all Input Types
5-16 Operation
Source Selector Dialog 2
Control Area
Input
Source Group
None button
Back button
Close button
After selecting a Stream, the Source Selector dialog is immediately closed.
Phase Inverts the audio signal for microphone and mono inputs; inverts the left
channel signal for stereo inputs, except in the RR case (see below) – then of
course it makes sense to invert the right channel signal. The Phase button
is highlighted whenever phase inversion is active.
Cal The input level calibration value is indicated by the blue bar graph; the exact
value is displayed in dB and can be set with the rotary encoder below.
Delay Since SW V3.0, a delay function has been added to systems using the SCore
Live (configuration C108). It is available for:
• All input channels at a fixed position after insert but pre-processing, which
allows individually selecting the insert send and the direct channel output
signals before or after processing and delay.
• Master, AUX, N–X and subgroup channels at a fixed position after the
limiter/compressor.
The delay can be set in a range of 0 to 5 s, in steps of 1 ms in the CHAN -
Input page of the respective channel. The channel and gain reduction meters
always indicate the delayed signal.
Note:
The mic clip limiter on/off button that was found on the CHAN - Input
pages of microphone inputs with SW versions before 3.0 was moved to the
configuration tool, refer to
SW V6.0
Stream Area
All Streams are listed here in
alphabetic order.
chapter 6.5.1.
Document generated: 10.10.14