Physical Output Mapping - Studer OnAir 3000 Operating Instructions Manual

OnAir Digital Mixing Consoles
6.6.1.2

Physical output Mapping

FCoreOut.OLeft
LogicalOutput A
FCoreOut.ORight
6-148 Configuration
As shown above, for Logical Input 90, "Missing Card" is indicated in place
of the card type only as it is mapped to an LVDS input.
Left- and Right Core Out of any output may be mapped to a LVDS Output
associated with an AoIP capable I/O card like the Livewire card in traditional
manner. (see chapter 6.5.3)
Physical Output Mapping
LVDS Out 1
LVDS Out 2
LVDS Out 15
LVDS Out 16
Note, that for special applications, where a codec is used in stereo or two mono
mode, two Logical- or Patch Outputs of format stereo must be configurable
as follows:
• The Left Core Out of Logical Output A must be mapped to the left channel
of a Talker. The Right Core Out of Logical Output A must not be mapped.
• The Left Core Out of Logical Output B must not be mapped. The Right
Core Out of Logical Output B must be mapped to the right channel of the
same Talker.
SW V6.0
Talker 1
Talker 8
Talker 9
Talker 16
Output Stream 1
Output Stream 8
Output Stream 9
Output Stream 16
Document generated: 10.10.14