Mic Group Page - Studer OnAir 3000 Operating Instructions Manual

INSERT1 - 8
5.3.5.4

Mic Group Page

MIC / POS
Assign / Clear
Document generated: 10.10.14
Touching one of these buttons opens a list of the available insert points to
select from. The selected insert point is displayed in the field at the right of
the INSERTx buttons. To de-assign an insert point, select None from the
list.
ON An insert point will become active in the audio signal path either upon touch-
ing the ON button or, as mentioned before, by activating it on the CHAN -
FDR/Bus page of the channel, or on the Sum - Master page of the master
to which the insert is assigned.
PP / AP For input channels only, the insert point can be set to either before (PP) or
after (AP) the signal processing.
Notes:
The audio inputs and outputs used for insert send and return are defined in
the configuration (see
5.1 input channels or master buses do not support inserts.
For ease of control, microphones may be grouped in Mic Groups. All micro-
phones within the same group may be switched on/off with one single, exter-
nal Mic key (via a GP input).
The microphone is selected with the rotary encoder below the MIC field, the
mic group with the one below the POS field.
Assignment of the selected microphone and group is done by touching
Assign; then a green bullet appears at the selected position. A touch on Clear
clears the selected assignment.
In the example above, the DJ mic and the guest mic #1 are assigned to mic
group 1, and the guest mic #2 is assigned to mic group 2; guest mic #3 is
ready to be assigned to mic group 2 – just touch Assign.
SW V6.0
OnAir 3000 Digital Mixing Console
chapters 6.5.5 and 6.5.6).
Operation 5-55