Logical Audio Outputs - Studer OnAir 3000 Operating Instructions Manual

OnAir 3000 Digital Mixing Console
5.8.1.3

Logical Audio Outputs

5-106 Operation
The following information affects the routing and is contained in the configu-
ration of a logical audio input:
• Input label
• Format (mono, stereo, or 5.1 channel surround)
• Left-channel audio input (physical input)
• If stereo: right-channel audio input (physical input)
• Listen only (inputs that can not be routed to channels, used e.g. for moni-
toring)
• Talkback audio signals.
Each stereo master has a stereo and a mono output simultaneously. They can
both be routed to logical audio outputs. The example below shows a situa-
tion where the PRG A master is used for a simultaneous transmission of the
program in stereo (FM) and in mono (AM).
Masters Output
Router
PGM A
PGM B
REC
#
AUX 1
AUX 4
N–X 1
A logical stereo output is connected to the master's stereo output, and a logi-
cal mono output is connected to the master's mono-mixed output. If a logical
stereo output is assigned to a mono master output, as the N–X 1in the example
above, the mono master signal is fed to both the left and right output connec-
tors. The mono/stereo output format is automatically handled and thus not
shown in the output routing page, from which results a very easy handling
of the output router.
Producer Format
5.1
Stereo
Mono
5.1
Stereo
Mono
5.1
Stereo
Mono
SW V6.0
Logical Physical
Outputs Outputs
L
ANT FM
R
LINE OUT Card
M
ANT AM
L
CD REC
R
LINE OUT Card
Consumer Format
5.1
5.1
5.1
Stereo
Stereo
Stereo
Mono
Mono
Mono
Document generated: 10.10.14
FM
AM
L
R
M
L
R
Routing Rule
1:1
L → L
R → R
M → L
M → R
L → L
R → R
1:1
M → L
M → R
C → M
L+R → M
1:1