Studer OnAir 3000 Operating Instructions Manual page 109

OnAir 3000 Digital Mixing Console
Downmix, ENC
5.3.4.2 CR/ST 1 LSP (Loudspeaker) Pages
Loudspeaker Volume
Loudspeaker ON - L, R, C, LFE, Ls, Rs (with surround option only)*
Near Field
Near Field ON - L, R
Near Field Volume
5-46 Operation
Direct Engaging this monitoring mode makes every signal pass through 'as is',
regardless of its format (e.g. 5.1-channel signals to all the individual speakers,
stereo signals to the L and R speakers only).
Stereo If active, a signal from a stereo source passes unprocessed to the L and R
speakers. If the monitored source is a 5.1-channel source, the signal is down-
mixed to a stereo signal, according to the Downmix / ENC setting.
These buttons determine whether a 5.1 signal gets 5.1 signal gets mixed down
either by the console's internal downmix processing or by an external encoder
(such as Dolby E
Note
If the 5.1-channel surround option is not installed, the right-hand part of the
screen only shows the Mono and Phase buttons.
Cut / Dim These buttons allow muting/dimming the speakers; highlighted if active. The
amount of Dim attenuation can be configured (see
The volume of the main monitoring system is indicated with the bar graph.
The exact value is displayed in dB and set with the adjacent rotary encoder.
If the surround option is installed, this rotary encoder controls the volume of
the of the main surround monitoring system.
Switches the the individual loudspeakers on/off.
(with surround option only)*
If active, the monitoring switches from the main surround monitoring system
over to the stereo-only near field monitoring system.
Switches the the individual near field loudspeakers on/off.
The volume of the near field monitoring system is indicated with the bar graph.
The exact value is displayed in dB and set with the adjacent rotary encoder.
Note If the 5.1-channel surround option is not installed, the Loudspeaker part
of the screen looks like the Near Field part shown above; there will be no
Near Field part available then.
SW V6.0
) when monitoring in Stereo mode.
®
chapter 6.5.24.1).
Document generated: 10.10.14