Studer OnAir 3000 Operating Instructions Manual page 125

OnAir 3000 Digital Mixing Console
Set Channel Filter ON/OFF
Set Location Filter ON/OFF
5.3.6.2 Route Page ('Partial Output Routing')
Routing Snapshot
5-62 Operation
Delete The Delete button is displayed only if an entry has been selected in the Local
snapshot list, and if deleting is available for this entry. It allows deleting the
selected entry after confirmation.
It is also possible to delete only a part (or parts) of a snapshot when selecting
one (or more) of the Audio, Rout In/Out, Assign buttons before touching
the Delete button. A confirmation dialog appears then as well.
Note: Global snapshots may be written, renamed, or deleted by the system admin-
istrator only.
The channel filter allows selecting channels to which the snapshot is loaded;
if ON, the SEL keys on the desk start flashing. Select the desired channel (or
channels) with its SEL key (that will be continuously illuminated then). When
touching >>, only the selected channel(s) will be overwritten with the snapshot
data of the input(s) with the matching alias label.
In certain cases, e.g. when operating in split desk mode, recalling a snapshot
in the control room must not affect the logical inputs located on a strip chan-
nel in the studios. It is also possible to load a snapshot individually on a split
desk or on one of the editor boxes with the SnapshotX desk key function. The
location filter button only appears when operating in split desk mode.
On this page the output routing may be partially changed. A recalled snapshot
only changes the routing nodes specified in the snapshot. This comes in very
handy if the recent routing of the console shall be kept, but the studio (PRG
Out) shall contribute to another on-air line, or, if in a split desk configura-
tion, the studio 2 operator's routing must be kept, but the routing for the CR
should be changed. The snapshots are configured in the configuration tool
(Config - PartialOutputRouting).
The rotary encoder below the field is used to select the desired routing snap-
shot from the list.
Load Loads the selected snapshot.
SW V6.0 Document generated: 10.10.14