Lldp Timer - Cisco 300 Series Cli Manual

Link Layer Discovery Protocol (LLDP) Commands
OL-32830-01 Command Line Interface Reference Guide
Parameters
seconds
reinit —Specifies the minimum time in seconds an LLDP port waits before
reinitializing LLDP transmission.(Range: 1–10)
Default Configuration
2 seconds
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)#

30.20 lldp timer

To specify how often the software sends LLDP updates, use the lldp timer Global
Configuration mode command. To restore the default configuration, use the no
form of this command.
Syntax
seconds
lldp timer
no lldp timer
Parameters
seconds
timer —Specifies, in seconds, how often the software sends LLDP
updates (range: 5-32768 seconds).
Default Configuration
30 seconds.
Command Mode
Global Configuration mode
lldp reinit 4
30
662