Show Bridge Multicast Address-Table - Cisco 300 Series Cli Manual

Address Table Commands
OL-32830-01 Command Line Interface Reference Guide
Example
The following example displays the Multicast bridging mode for all VLANs
switchxxxxxx# show bridge multicast mode
VLAN IPv4 Multicast Mode
Admin
----- -----------
1 MAC-GROUP
11 IPv4-GROUP
12 IPv4-SRC-
GROUP

5.29 show bridge multicast address-table

To display Multicast MAC addresses or IP Multicast address table information, use
the show bridge multicast address-table Privileged EXEC mode command.
Syntax
show bridge multicast address-table
show bridge multicast address-table
mac-multicast-address] [format {ip | mac}]
show bridge multicast address-table
ipv4-multicast-address] [source ipv4-source-address]
show bridge multicast address-table
ipv6-multicast-address] [source ipv6-source-address]
Parameters
•
vlan-id
vlan-id
•
address—(Optional) Display entries for specified Multicast address. The
possible values are:
-
mac-multicast-address—(Optional) Specifies the MAC Multicast
address.
IPv6 Multicast Mode
Oper Admin
----------- -----------
MAC-GROUP MAC-GROUP
IPv4-GROUP IPv6-GROUP
IPv4-SRC- IPv6-SRC-
GROUP GROUP
[vlan vlan-id]
[vlan vlan-id] [address
[vlan vlan-id] [address
[vlan vlan-id] [address
—(Optional) Display entries for specified VLAN ID.
Oper
-----------
MAC-GROUP
IPv6-GROUP
IPv6-SRC-
GROUP
5
176