Port Security Max - Cisco 300 Series Cli Manual

5
171
Lock for gi 1 4.
switchxxxxxx(config)#
switchxxxxxx(config-if)# port security mode
lock
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#

5.24 port security max

To configure the maximum number of addresses that can be learned on the port
while the port is in port, max-addresses or secure mode, use the port security
max Interface (Ethernet, Port Channel) Configuration mode command. To restore
the default configuration, use the no form of this command.
Syntax
max-addr
port security max
no port security max
Parameters
max-addr—Specifies the maximum number of addresses that can be learned on
the port. (Range: 0–256)
Default Configuration
This default maximum number of addresses is 1.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
The command may be used only when the interface in the regular (non-secure
with unlimited MAC learning) mode.
Use this command to change the default value before the
interface gi14
port security
exit
OL-32830-01 Command Line Interface Reference Guide
Address Table Commands
port security command.