Ipv6 Address Link-Local - Cisco 300 Series Cli Manual

IPv6 Commands
OL-32830-01 Command Line Interface Reference Guide
User Guidelines
If the value specified for the
prefix bits have precedence over the interface ID.
If the switch detects another host using one of its IPv6 addresses, it adds the IPv6
address and displays an error message on the console.
Using the no form of the
manually-configured IPv6 addresses from an interface, including link local
manually-configured addresses.
Example
The following example enables IPv6 processing on VLAN 1, configures IPv6 global
address 2001:0DB8:0:1::/64 and specifies an EUI-64 interface ID in the low order
64 bits of the address:
switchxxxxxx(config)#
switchxxxxxx(config-if)#
switchxxxxxx(config-if)#
27.5

ipv6 address link-local

Use the ipv6 address link-local command in Interface Configuration mode to
configure an IPv6 link local address for an interface and enable IPv6 processing on
the interface. To remove the manually configured link local address from the
interface, use the no form of this command.
Syntax
ipv6-prefix
ipv6 address
no ipv6 address [link-local]
Parameters
•
ipv6-address —Specifies the IPv6 network assigned to the interface. This
argument must be in the form documented in RFC4293 where the address
is specified in hexadecimal using 16-bit values between colons.
Default Configuration
The default Link-local address is defined.
prefix-length
argument is greater than 64 bits, the
ipv6 address command without arguments removes all
interface vlan 1
ipv6 address 2001:0DB8:0:1::/64 eui-64
exit
link-local
27
610