Show Cdp Entry - Cisco 300 Series Cli Manual

CDP Commands
OL-32830-01 Command Line Interface Reference Guide
Version TLV (0x0005)
Platform TLV (0x0006)
Sending CDPv2 advertisements is enabled
Sending Appliance TLV is enabled
Device ID format is Serial Number
Sending CDP packets every 60 seconds
Sending a holdtime value of 180 seconds
8.17

show cdp entry

The show cdp entry Privileged EXEC mode command displays information about
specific neighbor. Display can be limited to protocol or version information.
Syntax
device-name}
show cdp entry {* |
Parameters
•
*—Specifies all neighbors
•
device-name
—Specifies the name of the neighbor.
•
protocol—Limits the display to information about the protocols enabled on
neighbors.
•
version—Limits the display to information about the version of software
running on the neighbors.
Default Configuration
Version
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show cdp entry
device.cisco.com
Device ID: device.cisco.com
[protocol | version]
8
214