Show Fiber-Ports Optical-Transceiver - Cisco 300 Series Cli Manual

PHY Diagnostics Commands
OL-32830-01 Command Line Interface Reference Guide

35.4 show fiber-ports optical-transceiver

To display the optical transceiver diagnostics, use the show fiber-ports
optical-transceiver Privileged EXEC mode command.
Syntax
show fiber-ports optical-transceiver
Parameters
•
interface-id—(Optional) Specify an Ethernet port ID.
Default Configuration
All ports are displayed. If detailed is not used, only present ports are displayed.
Command Mode
Privileged EXEC mode
Examples
switchxxxxxx# show fiber-ports optical-transceiver
Port Temp Voltage Current Output
[C] [Volt]
----------- ------ ------- ------- ------- ------- ---
gi11 Copper
gi12 Copper
gi13 28 3.32
gi14 29 3.33
Temp - Internally measured transceiver temperature
Voltage - Internally measured supply voltage
Current - Measured TX bias current
Output Power - Measured TX output power in milliWatts
Input Power - Measured RX received power in milliWatts
LOS - Loss of signal
[interface interface-id
Input
[mA] Power Power
[mWatt] [mWatt]
7.26 3.53 3.68
6.50 3.53 3.71
]
LOS
No
No
35
722