Police Aggregate - Cisco 300 Series Cli Manual

39
Quality of Service (QoS) Commands
aggregate-policer policer1 96000 4800 exceed-action drop
.
not used by any policy map

39.16 police aggregate

Use the police aggregate Policy-map Class Configuration mode. command to
apply an aggregate policer to multiple class maps within the same policy map.
Use the no form of this command to remove an existing aggregate policer from a
policy map.
This command is only available in QoS advanced mode.
Syntax
aggregate-policer-name
police aggregate
aggregate-policer-name
no police aggregate
Parameters
aggregate-policer-name—Specifies the aggregate policer name.
Command Mode
Policy-map Class Configuration mode.
User Guidelines
An aggregate policer can be applied to multiple classes in the same policy map.
An aggregate policer cannot be applied across multiple policy maps or interfaces.
Use the exit command to return to the Configuration mode. Use the end command
to return to the Privileged EXEC mode.
This command does not work in Layer 3 mode.
Example
The following example applies the aggregate policer called Policer1 to a class
called class1 in a policy map called policy1 and class2 in policy map policy2.
switchxxxxxx(config)# qos aggregate-policer policer1 124000 9600 exceed-action
drop
policy1
switchxxxxxx(config)# policy-map
759 OL-32830-01 Command Line Interface Reference Guide