Power Inline Traps Enable; Power Inline Limit - Cisco 300 Series Cli Manual

36
Power over Ethernet (PoE) Commands

36.7 power inline traps enable

To enable inline power traps, use the power inline traps enable Global
Configuration mode command. To disable traps, use the no form of this command.
Syntax
power inline traps enable
no power inline traps enable
Default Configuration
Inline power traps are disabled.
Command Mode
Global Configuration mode
Example
The following example enables inline power traps.
switchxxxxxx(config)# power inline traps enable

36.8 power inline limit

To configure the power limit per port on an interface, use the power inline limit
Interface Configuration mode command. To return to default, use the no form of the
command.
Syntax
power
power inline limit
no power inline limit
Parameters
power—States the port power consumption limit in Milliwatts (Range:
0-15400 in case of AF port and 0-30000 in case of AT port)
729 OL-32830-01 Command Line Interface Reference Guide