Netbios-Name-Server - Cisco 300 Series Cli Manual

12
291
The following example shows a one-minute lease.
switchxxxxxx(config-dhcp)#
The following example shows an infinite (unlimited) lease.
switchxxxxxx(config-dhcp)#

12.14 netbios-name-server

To configure the NetBIOS Windows Internet Naming Service (WINS) server list that
is available to Microsoft DHCP clients, use the netbios-name-server in DHCP Pool
Network Configuration mode or in DHCP Pool Host Configuration mode. To
remove the NetBIOS name server list, use the no form of this command.
Syntax
netbios-name-server
no netbios-name-server
Parameters
•
ip-address ip-address2
[
NetBIOS WINS name servers. Up to eight addresses can be specified in
one command line.
Command Mode
DHCP Pool Network Configuration mode
DHCP Pool Host Configuration mode
Default Configuration
No bios server is defined.
Example
The following example specifies the IP address of a NetBIOS name server
available to the DHCP client.
lease 0 0 1
lease infinite
ip-address ip-address2
[
ip-address8
...
OL-32830-01 Command Line Interface Reference Guide
DHCP Server Commands
ip-address8
... ]
]—Specifies the IP addresses of