Lldp Reinit - Cisco 300 Series Cli Manual

30
Link Layer Discovery Protocol (LLDP) Commands
Syntax
lldp receive
no lldp receive
Parameters
This command has no arguments or keywords.
Default Configuration
Enabled
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
LLDP manages LAG ports individually. LLDP data received through LAG ports is
stored individually per port.
LLDP operation on a port is not dependent on the STP state of a port. I.e. LLDP
frames are received on blocked ports.
If a port is controlled by 802.1x, LLDP operates only if the port is authorized.
Example
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)#
lldp receive

30.19 lldp reinit

To specify the minimum time an LLDP port waits before reinitializing LLDP
transmission, use the lldp reinit Global Configuration mode command. To revert to
the default setting, use the no form of this command.
Syntax
seconds
lldp reinit
no lldp reinit
661 OL-32830-01 Command Line Interface Reference Guide