Management Acl Commands; Deny (Management) - Cisco 300 Series Cli Manual

Management ACL Commands

OL-32830-01 Command Line Interface Reference Guide
0
33.1

deny (Management)

To set permit rules (ACEs) for the management access list (ACL), use the deny
Management Access-list Configuration mode command.
Syntax
[interface-id] [service service]
deny
{ipv4-address | ipv6-address/ipv6-prefix-length} [mask {mask |
deny ip-source
prefix-length}] [interface-id] [service service]
Parameters
•
interface-id—(Optional) Specifies an interface ID. The interface ID can be
one of the following types: Ethernet port, Port-channel or VLAN
•
service
service
Telnet, SSH, HTTP, HTTPS and SNMP.
•
ipv4-address—Specifies the source IPv4 address.
•
ipv6-address/ipv6-prefix-length—Specifies the source IPv6 address and
source IPv6 address prefix length. The prefix length must be preceded by a
forward slash (/). The parameter is optional.
•
mask mask —Specifies the source IPv4 address network mask. The
parameter is relevant only to IPv4 addresses.
•
prefix-length
mask
IPv4 address prefix. The prefix length must be preceded by a forward slash
(/). The parameter is relevant only to IPv4 addresses. (Range: 0–32)
Default Configuration
No rules are configured.
—(Optional) Specifies the service type. Possible values are:
—Specifies the number of bits that comprise the source
33
698