Ip Igmp Snooping Vlan Mrouter - Cisco 300 Series Cli Manual

IGMP Snooping Commands
OL-32830-01 Command Line Interface Reference Guide
no ip igmp snooping vlan
Parameters
•
vlan-id
—Specifies the VLAN.
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
IGMP snooping can be enabled only on static VLANs.
IGMPv1, IGMPv2, and IGMPv3 Snooping are supported.
To activate IGMP snooping, bridge multicast filtering must be enabled by the
bridge multicast filtering
The user guidelines of the
configuration that is written into the FDB as a function of the FDB mode and the
IGMP version that is used in the network.
Example
switchxxxxxx(config)# ip igmp snooping vlan 2

21.3 ip igmp snooping vlan mrouter

To enable automatic learning of Multicast router ports on a VLAN, use the ip igmp
snooping vlan mrouter command in Global Configuration mode. To remove the
configuration, use the no form of this command.
Syntax
ip igmp snooping vlan
no ip igmp snooping vlan
Parameters
•
vlan-id
—Specifies the VLAN.
vlan-id
command.
bridge multicast mode
vlan-id
mrouter learn pim-dvmrp
vlan-id
mrouter learn pim-dvmrp
command describes the
21
434