Police - Cisco 300 Series Cli Manual

Quality of Service (QoS) Commands
OL-32830-01 Command Line Interface Reference Guide
switchxxxxxx(config-cmap)# match access-group ip1
switchxxxxxx(config-cmap)# exit
switchxxxxxx(config)# policy-map p1
switchxxxxxx(config-pmap)# class c1
switchxxxxxx(config-pmap-c)# set dscp

39.12 police

Use the police Policy-map Class Configuration mode. command to define the
policer for classified traffic. This defines another group of actions for the policy
map (per class map). Use the no form of this command to remove a policer.
Syntax
committed-rate-kbps committed-burst-byte
police
no police
Parameters
•
committed-rate-kbps
second (bps).(Range 100–10000000)
•
committed-burst-byte
(Range: 3000–19173960)
•
exceed-action—Specifies the action taken when the committed rate is
exceeded. If the keyword is not configured then the drop action is applied.
•
action
—Specifies the action taken when the committed rate is exceeded.
The possible values are:
-
drop—Drops the packet.
-
policed-dscp-transmit—Remarks the packet DSCP. The remarking is
configured by the qos map policed-dscp command.
Default Usage
No policer
Command Mode
Policy-map Class Configuration mode.
56
—Specifies the average traffic rate (CIR) in kbits per
—Specifies the normal burst size (CBS) in bytes.
action
[exceed-action
39
]
754