Bootfile - Cisco 300 Series Cli Manual

12
281
•
prefix-length
—Specifies the number of bits that comprise the address
prefix. The prefix is an alternative way of specifying the client network
mask. The prefix length must be preceded by a forward slash (/).
•
low-address
low
range.
•
high-address
high
range.
Default Configuration
DHCP address pools are not configured.
If the low address is not specified, it defaults to the first IP address in the network.
If the high address is not specified, it defaults to the last IP address in the network.
Command Mode
DHCP Pool Network Configuration mode
Example
The following example configures the subnet number and mask for a DHCP
address pool on a DHCP server.
switchxxxxxx(config-dhcp)#

12.3 bootfile

To specify the default boot image file name for a DHCP client, use the bootfile
command in DHCP Pool Network Configuration mode or in DHCP Pool Host
Configuration mode. To delete the boot image file name, use the no form of this
command.
Syntax
filename
bootfile
no bootfile
—Specifies the first IP address to use in the address
—Specifies the last IP address to use in the address
address 10.12.1.0 255.255.255.0
OL-32830-01 Command Line Interface Reference Guide
DHCP Server Commands